How to Change Oil in an Excavator

To change the oil in an excavator, follow these steps:

1. Park the excavator on a level surface and turn off the engine.

2. Locate the drain plug or valve on the engine oil pan or reservoir.

3. Place an oil drain pan beneath the drain plug or valve.

4. Unscrew the drain plug or open the valve to allow the old oil to drain into the pan.

5. Once the oil has fully drained, replace the drain plug or close the valve tightly.

6. Locate the oil filter and use an appropriate tool to remove it.

7. Apply a thin layer of fresh oil to the rubber gasket of the new oil filter.

8. Install the new oil filter by hand, ensuring it is tightened securely.

9. Remove the oil filler cap and pour the recommended amount of fresh oil into the reservoir.

10. Replace the oil filler cap and start the engine, allowing it to run for a few minutes.

11. Check the oil level using the dipstick and add more oil if necessary.

12. Dispose of the used oil and filter at a designated recycling facility.

 

---

Conseiller en vente : Mme Lucie	Conseiller de vente : Monsieur Marc
+86135-1090-74-01	+86135-1090-74-01
en direct:lucygao1520	en direct:qramei@126.com

Articles connexes